OIL Filtration SERVICES
PARTICULES REMOVAL SERVICE
Dirt contamination can become an issue within reservoirs causing premature pump and critical component failure. Our oil flushing service targets and removes these contaminants, therefore restoring the system’s fluid condition back to the recommended ISO cleanliness level. Our service includes on-site laser particle count fluid analysis equipment which allows our service technicians the ability continuously monitor the oil’s condition.
WATER / MOISTURE REMOVAL
Our service truck utilizes state of the art moisture sensory technology that aids in our ability to detect and remove moisture levels approximately 80% less than the amount found in standard virgin fluids. Moisture levels in oil below 100 ppm Lower moisture levels can promote longer bearing life and hinder oxidation from forming within the fluid.
INCORPORATES:
High Velocity Oil Flushing – Hot Oil Flushing – Our on-site oil flushing service can be performed while the unit is in operation. By keeping the unit in operation while our flush commences it allows the entire system to be flushed of water/dirt contamination. This eliminates the risk of hidden contaminants that may reside within oil lines and other piping components.
OIL PURIFIER BY THERMOVACUUM SYSTEM:
Total retention of free water, water in emulsion and dissolved water by mass transfer. Dissolved water control is essential to ensure the absence of free water during operation. With the PALL HLP purifier this is achieved in an effective, simple and reliable way.
ICOUNT PARTICLE COUNTER PS:
Parker’s Icount particle detector represents -the latest technology in solid particle detection by direct laser mechanism. Permanently provides the cleanliness code according to ISO 4406.
OIL FILTRATION UNIT BY FILTER-PRESSED SYSTEM:
Allows the retention of solid particles through its coalescing micron cellulose filter, with a retention capacity of 1 micron and BETA efficiency = 1.000 Product transfer capacity 30 gallons per minute.